QNAP TL-R1220Sep-RP 12 Bay 2U Rackmount SAS Storage Expansion Enclosure

Available Options
Special Bundle Offer with our recommended Seagate NAS Hard Drives (save up to 60%)
Special Bundle Offer with our recommended WD NAS Hard Drives (save up to 60%)

Available Options

Special Bundle Offer with our recommended Seagate NAS Hard Drives (save up to 60%)

Special Bundle Offer with our recommended WD NAS Hard Drives (save up to 60%)

Achieve up to 96Gb/s with link aggregation

The TL-R1220Sep-RP is powered by a low-power 28nm SAS35x28R SAS Expander and supports 12/6 Gb/s SAS/SATA drives. Also, it has four 12 Gb/s SAS 3.0 (x4 Lane) SFF-8644 SAS Wide Ports. By connecting the TL-R1220Sep-RP to the host NAS and daisy-chaining multiple JBODs with two wide ports configured with link aggregation, the solution delivers up to 96Gb/s transfer speed.

Supports SAS DataBolt™ technology, delivers 12Gb/s speed using existing 6Gb/s infrastructure

Featuring Broadcom® SAS DataBolt™ bandwidth optimization technology, the TL-R1220Sep-RP features an intelligent data buffer for transferring data to drives at speeds that match the performance of the host NAS. Whether the TL-R1220Sep-RP uses 12Gb/s or 6Gb/s drives, the NAS host will transfer data to the TL-R1220Sep-RP at 12Gb/s, allowing you benefit from high-speed 12Gb/s SAS transmission with existing 6Gb/s infrastructure.

Note: The QNAP host NAS requires QTS 4.5.1 / QuTS hero h4.5.1 (or later) with a PCIe SAS storage expansion card installed. Check PCIe SAS card compatibility

Connect up to 16 JBODs, support up to 3.4 PB raw capacity

The TL-R1220Sep-RP has four 12 Gb/s SAS 3.0 (x4 Lane) SFF-8644 SAS Wide Ports. Up to sixteen TL-R1220Sep-RP can be daisy-chained to achieve a raw capacity of up to 3.4PB.

Note:
1. Use the CAB-SAS10M-8644-8088 12Gb/s to 6Gb/s external cable to connect to SAS NAS / REXP expansion enclosures and 6 Gb/s SAS HBA.
2. The host NAS requires one QXP-1620S-B3616W SAS card to daisy chain sixteen JBODs with single path routing. Using multipath routing with link aggregation enabled, the host NAS with one QXP-1620S-B3616W SAS card can daisy chain four JBODs; the host NAS with two QXP-1620S-B3616W SAS cards can daisy chain eight JBODs.

Multipath routing to ensure continuous system operations

By daisy chaining the TL-R1220Sep-RP, data transmission loads can be balanced with multipath routing to achieve high availability. If one route fails, another transmission route can be used to access the data and ensure continuous system operations. The TL-R1220Sep-RP also features a redundant power supply to ensure system uptime.

Note: Multipath routing requires a host NAS with QTS 4.5.1 / QuTS hero h4.5.1 (or later).

Storage Management

With Storage & Snapshot Manager on the host NAS, you can configure and manage the TL-R1220Sep-RP settings (including RAID groups, storage pools and snapshots), allowing you to easily expand NAS storage to accommodate massive data or backup files. You can also configure and manage the TL-R1220Sep-RP via the Console Port.

Speed up remote file transfers with JBOD migration

Moving many small files or a single large data file over a network can be time-consuming and negatively impact network performance. By setting up the RAID configuration on the TL-R1220Sep-RP, you can use it to move files to another computer or NAS. Simply save the files to the TL-R1220Sep-RP, connect it to the destination device, and then copy the files over.

Note: When using software RAID configuration, the TL-R1220Sep-RP migration only supports hosts that use the same operating system.

Warranty

Maunfacturer Warranty: 5 Years Maunfacturer Warranty

Specifications

TL-R1220Sep-RP

Download Datasheet
Download Datasheet
Download Datasheet

Drive Bay	12 x 3.5-inch SAS 12Gb/s, SAS/SATA 6Gb/s The system is shipped without HDD. For the HDD compatibility list, please visit https://www.qnap.com/compatibility/
Drive Compatibility	3.5-inch bays: 3.5-inch SAS/SATA hard disk drives 2.5-inch SAS/SATA hard disk drives 2.5-inch SAS/SATA solid state drives
Hot-swappable
Form Factor	2U Rackmount
Host Interface	4 x Mini-SAS HD (SFF-8644)
LED Indicators	Front panel: HDD 1-12, Power, Status, Link, Fan error Rear panel: SAS connector, Enclosure ID
Buttons	Power
Dimensions (HxWxD)	88.65 × 482.2 × 423.8 mm
Weight (Net)	9.19 kg
Weight (Gross)	14.03 kg
Max. number of HDDs/SSDs supported	12
Hard Drive Type	3.5" or 2.5" SAS 12Gb/s, SAS/SATA 6Gb/s and 3Gb/s drives
Operating temperature	0 - 40 °C (32°F - 104°F)
Storage Temperature	-20 - 70°C (-4°F - 158°F)
Relative Humidity	5-95% RH non-condensing, wet bulb: 27˚C (80.6˚F)
Power Supply Unit	300W (x2), 100 - 240V
Power Consumption: Operating Mode, Typical	163.38 W Tested with drives fully populated.
Fan	2 x 80mm, 12VDC
Sound Level	33.9 db(A)
System Warning	Buzzer
Management	Managed via QNAP QTS / QuTS hero OS 1. Supports disk S.M.A.R.T. information 2. RAID expansion enclosure identifier 3. Locate RAID expansion enclosures 4. Locate hard disks on RAID expansion enclosure 5. Smart fan control by detecting system and hard drive temperature 6. In-band SAS firmware update

Note: Use only QNAP memory modules to maintain system performance and stability. For NAS devices with more than one memory slot, use QNAP modules with identical specifications.
Warning: Using unsupported modules may degrade performance, cause errors, or prevent the operating system from starting.
* Sound Level Test
Environment: Refer to ISO 7779; Maximum HDD loaded; Bystander Position; Average data from 1 meter in front of operating NAS.
Product images are for illustrative purposes only and may differ from the actual product. Due to differences in monitors, colors of products may also appear different to those shown on the site.
Designs and specifications are subject to change without notice.

SKU	TL-R1220Sep-RP
Brand	QNAP
Shipping Weight	27.0000kg

Others Also Bought

QNAP TR-004 4 BAY DAS(NO DISK) HARDWARE RAID EXPANSION FOR QNAP NAS WINMAC

$377.00 $309.00

SKU: TR-004

More From This Category

QNAP TL-R1200S-RP 12-bay 2U rackmount SATA JBOD expansion unit, redundant PSU

$2,054.00 $1,648.00

SKU: TL-R1200S-RP

Supported NAS System	DataBolt Bandwidth Optimization	Multipath Routing
Expand the storage space of a QTS/QuTS hero NAS, supports up to 3.4PB raw capacity by daisy-chaining up to 16 expansion enclosures.	Combine multiple 6Gb/s transmissions into 12 Gb/s data streams to achieve faster speed with existing 6Gb/s infrastructure.	Ensure smooth data transmission and continuous operation by using the TL-R1220Sep-RP with a NAS that supports multipath routing.
Storage Management	Remote Files Transfer	Easy Installation & Storage
Manage the storage space and settings of the TL-R1220Sep-RP with Storage & Snapshot Manager on the host NAS.	Conserve network bandwidth and performance by using the TL-R1220Sep-RP to transfer huge files from one device to another.	With a short-depth design, the TL-R1220Sep-RP is suitable for universal deployment.

Model	QXP-1620S-B3616W	QXP-820S-B3408
SAS controller	Broadcom SAS3616W Tri-mode	Broadcom SAS3408 Tri-mode
Ports	4 Wide Ports (each port contains 4 12Gb/s SAS signals)	2 Wide Ports (each port contains 4 12Gb/s SAS signals)
Interface	PCIe Gen 3 x16	PCIe Gen 3 x8

QNAP TL-R1220Sep-RP 12 Bay 2U Rackmount SAS Storage Expansion Enclosure

Model # TL-R1220Sep-RP

Calculate Shipping

Notify me when back in stock

Description

Achieve up to 96Gb/s with link aggregation

Ultimate performance for enterprise applications

Virtualization Certifications Supported by TL-R1220Sep-RP

Supports SAS DataBolt™ technology, delivers 12Gb/s speed using existing 6Gb/s infrastructure

Short-depth design Can be installed in standard server racks or small AV cabinets

Connect up to 16 JBODs, support up to 3.4 PB raw capacity

Multipath routing to ensure continuous system operations

Flexible daisy chaining modes

High Storage Capacity

Storage Management

Speed up remote file transfers with JBOD migration

Applicable PCIe SAS storage expansion card

Warranty

Specifications

TL-R1220Sep-RP

Others Also Bought

More From This Category

Stay Updated

Secure Payment Options

Encrypted Checkout

Service

About Us

Information

Short-depth design
Can be installed in standard server racks or small AV cabinets